http://www.bike-turbo.com/forum/viewtopic,p,43620.html

I thought this might be of interest to Judley and Imp Paul.

Its built by a guy called Doug (good name) Meyers in the states and was used to set the landspeed record for a bike with paniers/saddlebags on!
It reached 219mph.

The engine made 423bhp on a lower boost setting.

Spec and pics

84mm small pin turbo pistons $288
Custom small pin rod bushings
2nd inlet cam (used @exhaust side)
Adjustable cam sprockets
Turbo valve springs (high press inlet) $226
Cylinder head studs/nuts
Freshly fit main and rod bearings
Turbonetics T3/T4 Hybrid Turbo $1040
Multi-stage waste gate $335
Fuel pump $572
Fuel pressure regulator $331
550 cc injectors $267
Muzzy billet velocity stacks
Stainless Turbo exhaust $335
Stainless inlet ducting $170
Billet airbox (frame) filter block-offs
Billet oil filter relocation housing
Turbo scavenge pump $203
Muzzy clutch kit incl. drilled hub, springs/plates
Electronics:
DTA ECU (incl. software) $750
Innovative Multi stage boost controller (faulty)
Boost controller solenoids
Complete DTA wiring harness $146
DTA Computer data download cable
Air temp sensor
Water temp sensor
3 bar ABS sensor $75
7mm plug wires
Data acquisition:
Racepak V300 Data Recorder
8 channel (4 digital, 4 analog) $1395
4 probe EGT Option (incl. Probes) $671
UEGO O2 Sensor $600
UEGO Data Controller $400
V300 Clutch RPM upgrade $250
V300 Air Fuel module $150
Back pressure monitor $238
Manifold presser sensor $238
All necessary software

http://i167.photobucket.com/albums/u156/IGO200/DSCF5244.jpg

http://i167.photobucket.com/albums/u156/IGO200/DSCF5183.jpg

_________________
Welcome, my name is Doug and I am a boostaholic.

Wow it is really amazing, you have done a great job in engine, i think you have upgrade so many parts in this engine, its look very nice, i appreciate your work, thanks for sharing a wonder spec and pics of your work.

Wow, that is a work of art!!

By the looks of the work you have don on your 12 you may know the answer to my question....

The two bolts that go into the head just above the two middle exhaust ports, can they be safely drilled out and hellicoiled at 8mm?

Only asking as one of mine has stripped and I am bit worried about drilling it out and taking the edge of a water jacket with it..

Once again, Nice work!

Dale :)

that is sick dude. :O

Love it!! :-)